Magnetization process of electric permanent magnet sucker
Turn over the POWER supply (press the “-” side of the power key), you will see the LED indicator light on the panel is red, indicating that the self-test has passed, the circuit is working normally, and the operation can continue.

Pre-magnetization operation: press the confirm and magnetization buttons on the board together (special model is to press the Confirm button), and the controller performs the magnetization operation according to the parameters set by the pre-magnetization intensity.

IMG：Machining center electric permanent magnet sucker

Magnetization operation: Press the magnetization button, and the controller performs magnetization operation according to the parameters set by the magnetization intensity.

Demagnetization operation: press the Confirm and demagnetization keys together (special model is to press the demagnetization key), and the controller performs demagnetization operation according to the demagnetization intensity setting parameters.

Status indicator: The green indicator on the controller is on after successful magnetization operation, the yellow indicator on the controller is on after successful premagnetization operation, the red indicator on the controller is on after successful demagnetization operation, and the successful demagnetization indicator on the controller is on together with the successful demagnetization indicator on the controller.

IMG：Cylindrical rod and tube transport electric permanent magnet sucker

Electric permanent magnet chuck remote control use
Remote control START: After the body is turned on, press the green “Start” button at the top of the remote control, the remote control transmitter LED light will emit green light, and the surface remote control has started. You can perform any of the following three steps.

Pre-magnetization operation: press the START (lock)+▲ (MAG/ magnetization) button on the panel at the same time to start the pre-magnetization action.

Magnetization operation: Press the ▲(MAG/ magnetization) button on the panel to start the magnetization action.
Demagnetization operation: Press the START(lock)+▲ (DEMAG/ Demagnetization) button on the panel to start the demagnetization action.

Status indicator: The green indicator on the controller is on after successful magnetization, the yellow indicator on the controller is on after successful premagnetization, the red indicator on the controller is on after successful demagnetization, and the successful and successful demagnetization indicators on the controller are on at the same time.