Home > Support > Technical principles
Technical principle of vacuum sucker spreader
Time: 2023-10-07 Visit: 36 Type size

一.The use of vacuum sucker hanger

 

1. Non-ferrous metal industry: aluminum ingot, aluminum plate, aircraft plate, copper plate, copper ingot, copper coil, magnesium alloy plate;

 

2. Steel industry: ingot, steel plate, steel pipe, steel coil, forgings;

 

3. Concrete industry: precast concrete components, cement slabs, pieces, columns, piles, Bridges, frames;

 

4. Raw material industry: paper, aluminum processing, wood processing, plastic processing, etc.;

 

5. Processing industry: machine tools, home appliances, glass, buses; All walks of life have applications, the use of vacuum sucker lifting conditions are slightly different.

 

二.Technical analysis diagram of vacuum sucker spreader

 

Technical principle of vacuum sucker spreader

 

三.Characteristics of the vacuum sucker hanger:

 

1. Low noise: In addition to the noise generated by the carrier, such as forklifts, loaders, excavators, etc., the suction crane itself almost does not produce noise. If the mobile cantilever and beam are used as the carrier, the impact on the surrounding environment is very small.

 

2. High safety: Vacuum adsorption is pumped through the vacuum pump vacuum storage, and then control: in case of power (power) failure, such as power failure: it can still firmly absorb the adsorbed object, to ensure that there is enough time to take measures.

 

The total adsorption capacity of each sucker is more than 2.5 times the weight of the object.

 

When the sucker adsorbs the object, as long as the indicator light (green) controlling the sucker is on, it indicates that the vacuum level is greater than 80%, and only when the indicator light shows green, you can lift.

 

The vacuum storage can enable the suspended workpiece to be suspended for more than 20 minutes in the case of power failure. (Of course, this also depends on the degree of sealing of the rubber strip) The equipment should be equipped with a battery, which can ensure that the safety signal continues to work when the power is off, so that it plays a safety insurance role.

 

In addition, the device also has a safe release detection device. Only when the object to be suspended is safely placed on the ground or support, it can be safely released, which is another safety insurance role.

 

3. Simple operation: the adsorption and release time of design and installation debugging is 3 seconds (of course, it can be faster 2 seconds), so the hoisting and transporting process of large projects (workpieces) takes less time and has high efficiency.

+86-400-000-3835